TX packets:424 errors:0 dropped:0 overruns:0 carrier:0 RX packets:1855 errors:0 dropped:0 overruns:0 frame:0 My current setup is available through ifconfig ifconfigĮth0 Link encap:Ethernet HWaddr C8:A0:30:AB:32:3A So, just be careful that you choose a static address that does not clash with an existing device on your network. On my network I have configured the router so that it gives out DHCP addresses in the range 100-255, so below 100 is available to be fixed. Linux beaglebone 3.8.11 #1 SMP Wed May 8 07:34:27 CEST 2013 armv7l GNU/Linux The current configuration in this part is Angstrom on Beaglebone Black with: ![]() TX packets:130 errors:0 dropped:0 overruns:0 carrier:0 RX packets:672 errors:0 dropped:0 overruns:0 frame:0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 After you reboot the BeagleBone and connect via USB-over-Internet (or directly to the new static IP address) you can view your configuration as ifconfigĮth0 Link encap:Ethernet HWaddr d0:5f:b8:fe:39:93 Do not pick an address that is within the DHCP pool or assigned to another device, or it will result in IP conflicts on the network. ![]() The same procedure applies to other adapter entries, such as the wlan0 wireless Ethernet adapter. The BBB then has a static IP address after reboot. Linux beaglebone 3.8.13-bone70 #1 SMP Fri Jan 23 02:15: armv7l cd sudo nano interfacesĪnd, edit the interfaces file as more interfaces Use an editor, such as nano, to edit the /etc/network/interfaces file and For example, the settings for my network, which has a common configuration, are as uname -a You can simply alter the /etc/network/interfaces configuration file to manually specify the address (e.g., 192.168.1.80 in this case), the network mask, and the network gateway. To set the IP address to be static under Debian is quite straightforward. The following description details the steps required to set your IP address to be static under Debian and Angstrom. This is because DHCP devices may receive a different IP address each time they boot (depending on the router’s lease time). ![]() While DHCP works well for most devices on a local network, it can cause difficulties if you wish to make the BBB visible outside a home firewall via port forwarding. Network routers typically run a DHCP server that allocates a pool of addresses to devices attached to the network. The BBB is configured by default to use the dynamic host configuration protocol (DHCP) for the allocation of its wired and wireless IP address. 3.3 Step 2- Changing the Network Settings.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |